Wanlan ad-hoc network radio 70 km test
Test time: 2023-03-31
Tester: project customers and Wanlan technical support personnel
Test Objectives
Through the test, understand the function and completion of the product, verify the consistency of the actual performance of the main parameters such as point-to-point bandwidth, cold start time, and access time after start-up with the product manual, and further communicate the product details and follow-up cooperation methods.
Test points
SITE A IS LOCATED AT AN ALTITUDE OF ABOUT 1 KM ON THE TOP OF MIAOFENG MOUNTAIN, AND SITE B IS LOCATED AT AN ALTITUDE OF ABOUT -50 M ABOVE SEA LEVEL ON TANGZHI MOUNTAIN NEXT TO SHIZHONGWU VILLAGE, AND THE DISTANCE BETWEEN THE TWO PLACES IS ABOUT 70KM, AND THERE IS OCCASIONAL BASE STATION COMMUNICATION INTERFERENCE, the middle shrubs, the mountains are slightly shaded.

Location A

地点B
妙峰山顶设备为 AnyMesh-SDR-A2-2*20W 车载背负式自组网电台,我们称其为电台A,放置于山顶平地,用三角支架撑高约3米, 连接手咪实现实现语音对讲,本地电脑连接该电台用以接收远处灌包数据
史中坞村旁边唐指山水库路边台子上(高约1米多)同样放置AnyMesh-SDR-A2-2*20W车载背负式自组网电台,我们称其为电台B,连接手咪实现实现语音对讲,本地电脑连接该电台用以接收远处灌包数据。
测试设备
自组网车载背负台
产品名称 | ANYMESH-SDR-A2(40W)自组网车载背负台 |
所属类别 | 自组网车载背负台(基站) |
Product model | ANYMESH-SDR-A2(40W) |
Product Introduction | The ANYMESH-SDR-A2 is a base station-type ad hoc network device that can be carried behind you to reduce extra weight or be fixed as a relay base station. The chain can be automatically built and networked after powering on the computer, and no additional configuration work is required. Each piggyback base station node does not need to forward data information through the central node, and all nodes can be used as data information collection node, relay forwarding node and data information output node at the same time. The networking mode dynamically changes with the environment to meet the requirements of multi-scenario applications. The transmission distance of the equipment can reach more than 50KM in an unobstructed environment, and it is effectively used in various severe environmental fields |

The vehicle-mounted ad hoc network radio adopts the radio technology of Wanlan Communication's new generation of multi-hop ad hoc network protocol, which has the ability to resist complex channel environments and realize the centerless same-frequency ad hoc network broadband service transmission between individual soldiers, vehicles, UAVs and other maneuvering points and fixed points in complex scenarios.
The device itself has a built-in large-capacity lithium battery, compact design, and a transmission power of 2*40W for a single channel and 4 0W for a dual channel, which can meet the user's ability to quickly establish a private network in emergency scenarios and provide a stable transmission channel for the user's voice, message, video and other IP data services.
The product has the characteristics of software defined radio, which is very suitable for military and firefighting fields, and is also suitable for moving vehicles and ship equipment, so as to realize uninterrupted communication between vehicles and vehicles.
It is widely used in smart cities, individual soldiers, public security and armed police, fire rescue, emergency fleet communications, civil air defense border defense, marine unmanned ships, special robots and other fields.
Testing process
Ad hoc network device testing |
|
|
|
project | Test Method: | Test results | remark |
40W ad hoc network radio | Power 40W, channel bandwidth 20MHz/10MHz, MIMO mode | 10MHz, 40W average 11.2, 10MHz, 20W average 11.1, | 70 km bandwidth packet speed measurement |
Omnidirectional fiberglass antenna | 4 antennas | Frequency range 1200-1500 MHz, antenna gain 8dBi |
|
Software | 2 sets of PC-related tools iperf3 software | Includes network management software system |
|
fittings | 2 network cables, voice cables, hand microphones and radio stands | It is about 3 meters high |
|
AD HOC NETWORK PULL-DISTANCE NETWORKING TEST (70KM TEST).
2023.3.31 Arrived at the two places at 11:00 to debug the equipment, and after trying to clean the noise and signal strength of the channel 13 80, the test began, and the distance between the two places was about 70KM, Radio A and Radio B are successfully organized and the link is in good condition

70 km 10MHz, 40W point-to-point bandwidth speed measurement
Sender:

At 20 MHz bandwidth, the peak packet filling rate is 11.8 Mbit/s, and the average rate is 11.2 Mbps
Receiver:

At 20 MHz bandwidth, the peak packet filling rate is 11.8 Mbit/s, and the average rate is 11.2 Mbps
70km 10MHz, 20W point-to-point bandwidth speed measurement
Sender:

Under 10 MHz bandwidth, the peak packet filling rate is 11.6 Mbit/s, and the average rate is 11.1 Mbit/s
Receiver:

Under 10 MHz bandwidth: the peak packet filling rate is 11.7 Mbit/s, and the average rate is 11.0 Mbps
Test conclusion: Using our 10MHz, 2*40W ad hoc network radio in 70KM cross-urban area point-to-point packet filling speed measurement of more than 11M, the communication link is very stable.
The channel bandwidth of the stations on both sides is 10 MHz, and the 40W transmission rate is recorded as follows:
Points | Average rate | Highest rate | Audio and video stability |
Radio A | 11.1Mbps | 11.6Mbps | Very stable |
Radio B | 11.2Mbps | 11.7Mbps | Very stable |
The channel bandwidth of the stations on both sides is set to 10 MHz, and the 20W transmission rate is recorded as follows:
Points | Average rate | Highest rate | Audio and video stability |
Radio A | 11.1Mbps | 11.6Mbps | Very stable |
Radio B | 11.0Mbps | 11.7Mbps | Very stable |
Wanlan Communication Test Time 20233.31